Display Assembly, Display Latch, and Hinge Covers: Dell Latitude C610/C510 Service Manual
2 M2.5 x 5-mm screws (6) 6 display-feed flex cable
3 display bezel
4 top cover
Removing the 14.1-Inch Display Bezel
NOTICE:
Disconnect the computer and any attached devices from electrical outlets, and
remove any installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by touching
an unpainted metal surface on the computer.
NOTICE:
Read
procedure.
1. Remove the
hard
2. Remove the
display
3. Use a plastic scribe to pry the six rubber screw covers out of the screw holes located on
the front of the bezel.
4. Remove the six M2.5 x 5-mm screws located on the front of the bezel.
NOTICE:
Carefully separate the bezel from the top cover to avoid damage to the bezel.
5. Starting at the bottom of the display panel (by the Dell™ logo), use your fingers to
separate the bezel from the top cover by lifting up the inside of the bezel while pushing in
on the outside.
Removing the 14.1-Inch Display Panel
NOTICE:
Disconnect the computer and any attached devices from electrical outlets, and
remove any installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by touching
an unpainted metal surface on the computer.
NOTICE:
Read
procedure.
file:///F|/Service%20Manuals/Dell/Latitude/c510-610/display.htm (5 of 12) [2/28/2004 7:55:49 AM]
7 flex-cable retention bracket
8 display panel
"Preparing to Work Inside the
drive.
assembly.
"Preparing to Work Inside the
Computer" before performing the following
Computer" before performing the following