Dell Latitude C610 Service Manual page 31

Display Assembly, Display Latch, and Hinge Covers: Dell Latitude C610/C510 Service Manual
5. From the back of the computer, remove the five M2.5 x 5-mm screws labeled "circle D."
6. Open the display assembly approximately 180 degrees and support the display assembly
so that it does not open past this position.
7. Remove the two M2 x 3-mm screws on the EMI shield bracket, which is attached to the
display-feed flex cable (see
8. Remove the two M2 x 3-mm screws that secure the display-feed flex cable to the system
board (see "Display-Feed Flex Cable
Display-Feed Flex Cable Connector
NOTICE: When reconnecting the display-feed flex cable connector to the system board,
push down on the top left and right ends of the connector. Pressing on the center of the
connector may damage resistors and compromise EMI protection in the computer.
1 M2 x 3-mm screws (2)
file:///F|/Service%20Manuals/Dell/Latitude/c510-610/display.htm (3 of 12) [2/28/2004 7:55:49 AM]
"Display Assembly").
Connector").