Shure Microflex MX400SE Series User Manual page 12

MX412/MX418 SCHEMATIC • MX412/MX418 SCHÉMA • MX412/MX418 DIAGRAMM • MX412/MX418 DIAGRAMA
NOTES:
1. All resistors1/10 Watt, 1%, 0805 unless otherwise specified.
2. Electrolytic capacitors shown in F, 10%, 50V or more, unlss otherwise specified.
3. The following symbols denote:
A.C. Voltage A.C. Voltage, Mic Off
D.C. Voltage D.C. Voltage, Mic Off
(+) / (–) indicate A.C. polarity relative to
input test signal.
4. All voltages measured with input driven by a 0.1 Vrms, 1kHz signal through the test circuit shown below. A Shure M367 mixer or
equivalent, with 48 V phantom power switched on, supplies the required power and load to preamplifier.
ESQUEMÁTICO • MX412/MX418 SCHEMA
FIGURE 9 • ABBILDUNG 9 • FIGURA 9
Printed Clrcuit Ground
Case Ground
SHURE Incorporated Web Address: http://www.shure.com
5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A.
In U.S.A., Phone: 1-847-600-2000 Fax: 1-847-600-1212
In Europe, Phone: 49-7131-72140 Fax: 49-7131-721414
In Asia, Phone: 1-852-2893-4290 Fax: 1-852-2893-4055
International Fax: 1-847-600-6446