Carrier AQUAZONE 50RHC006-060 Series Product Data page 33

AL — Alarm Relay Contacts
BM — Blower Motor
BMC — Blower Motor Capacitor
CAP — Capacitor
CB — Circuit Breaker
CC — Compressor Contactor
CO — Sensor, Condensate Overflow
FP1 — Sensor, Water Coil Freeze Protection
FP2 — Sensor, Air Coil Freeze Protection
HP — High-Pressure Switch
HWTS — High (Leaving) Water Temp Switch
JW1 — Jumper, Alarm
LOC — Loss of Charge Pressure Switch
NOTES:
1. Compressor and blower motor thermally protected internally.
2. All wiring to the unit must comply with NEC and local codes.
3. Transformer is wired to 208 v (RED) lead for 208/3/60. For 230/3/60
switch RED and ORG leads at L1 and insulate RED lead.
4. FP1 thermistor provides freeze protection for water. When using anti-
freeze solutions, cut JW3 jumper.
5. Typical Aquazone thermostat wiring shown. Refer to thermostat instal-
lation instructions for wiring to the unit. Thermostat wiring must be
Class 1 and voltage rating equal to or greater than unit supply voltage.
6. 24-v alarm signal shown. For dry alarm contact, cut AL2 dry jumper
and dry contact will be available between AL1 and AL2.
TYPICAL AQUAZONE™ DELUXE D CONTROL WIRING
LEGEND
MV — Motorized Valve
P1 — Field Wiring Terminal Block
PM — Performance Monitor
RVS — Reversing Valve Solenoid
TRANS — Transformer
TXV — Thermostatic Expansion Valve
Field Line Voltage Wiring
Field Low Voltage Wiring
Printed Circuit Trace
7. Transformer secondary ground via control board standoffs
and screws to control box. (Ground available from top two
standoffs as shown.)
8. Blower motor is factory wired for medium and high speeds.
For any other combination of speeds, attach the lower
speed wire to fan speed relay N.O. wire.
9. Aquastat is supplied with unit and must be wired in series
with hot leg to the pump. Aquastat is rated for voltages up to
277 v.
Relay/Contactor Coil
Condensate Pan
Solenoid Coil
Thermistor
Ground
Wire Nut
33