Typical Piping And Wiring - Carrier AQUAZONE 50RHC006-060 Series Product Data

Typical piping and wiring

Field-supplied transition to
minimize pressure loss
Supply Air
Insulated supply duct with
at least one 90 degree elbow
to reduce air noise
(field supplied)
TYPICAL INSTALLATION — 50RHC UNITS
Filter Access
Flexible
Connection
Unit Power
Accessory
Disconnect
Electric Heat
(if applicable)
Unit Hanger
3/8" Threaded
Rod (by others)
Vibration Isolator
(white compressor end
and red blower end)
Washer
(by others)
Double Hex Nuts
(by others)
Integral hanger support-
pre-attached in factory
TYPICAL VERTICAL INSTALLATION — 50RVC UNITS
Return
Air
Power
Thermostat
Wiring
Compressor
Access Panel
Return Loop
3/8" threaded rods
Supply Loop
(by others)
Return Air
(Ductwork
not shown)
Thermostat
Wiring
Power Wiring
Accessory
stainless steel
braid hose
with integral
"J" swivel
Unit Power
Supply Air
Building
Loop
Flexible
Connection
Water
Out
Balancing Valve
(field-installed
and calibrated
accessory)
Field-supplied
stainless steel
braid hose
with integral
" J" swivel
Water In
Water Out
Balancing Valve (Field
installed and calibrated
accessory)
Low Pressure Drop Water
Control Valve (optional) or
(field-installed accessory)
Water Out
Water In
Ball Valve Accessory with optional
integral P/T plug (typical for supply
and return piping)
NOTE: Ball valve with inte-
gral pressure temperature
plug recommended.
Water
In
Low Pressure
Drop Water
Control Valve (Optional)
(field-installed
accessory)
Ball Valve with optional
integral P/T plug
(typical for supply and
return piping)
31