Connecting A Camera - Swann RedAlert2 Operating Instructions Manual

Connecting a Camera

Your RedAlert2 can be connected to a single wired camera and/or a single wireless
camera. Note that it can only monitor and record from one of these at a time.
Connecting either type of camera is a simple operation.
The RedAlert2 is compatible with all wired cameras which output a composite
video signal at standard definition or lower. It is also compatible with most analog
wireless cameras which transmit in the 2.4GHz range. Note that the RedAlert2 is
NOT compatible with digital wireless cameras as these use a very different method
of wireless transmission.
Swann offer an extensive range of both types of cameras. They'll typically available
from the same retailer from whom you purchased the RedAlert2.
Attaching a Wired Camera:
The basic setup for a wired
camera is quite simple. The
camera needs to be supplied
with power, and the video out
cable (typically using an RCA or
a BNC connection) needs to be
connected to the RedAlert2.
If the camera has a BNC output
TO REDALERT2
plug, you'll need to use a BNC
to RCA adaptor.
Example image of a Wired Camera Setup
Attaching a Wireless Camera:
The basic setup for a wireless camera is even easier! A wireless camera simply
needs to be connected to power using it's power supply (batteries don't last very
long). You may need to change/set the wireless frequency on the camera - consult
the camera's user manual for information on how to do this (typically, it's done
with dip switches, but there are many methods).
The most important thing to remember when configuring a wireless setup is camera
placement relative to the RedAlert2. See page 11 for much more information about
wireless interference, and some common steps which help to avoid it.
Remember:
Wireless cameras are not cordless, and do require power!
The term 'wireless' refers to there being no direct
connection between the camera and the RedAlert2.
6 6 6