AMT Datasouth Fastmark 600 Series User Manual page 74

Description of Issue
LEDs indicate Media
Out
Text prints off the
right of left side of
the media
Printer feeds out
multiple blank labels
before printing
Fastmark 600 Series User's Guide
Possible Problem
Media Latches not closed.
Or Media is too far from
the Media Sensor to be
detected.
Media Guide not in the
proper position.
Media is not going Flat
across the sensor.
Media not Calibrated
Media Sensor needs to be
cleaned
Improper loading of the
stock.
Width of stock is incorrect.
Media is not Calibrated
Media not installed under
Media Guides
Media Sensor not
functioning
Backing of stock to dark to
properly sense
Possible Correcting Procedures
1. Open the Top Cover.
2. Press firmly on the top of the Printhead Mechanism
and verify the both the right and left latches are locked.
3. Close the Top Cover.
1. Verify Media is installed under the media guides.
2. Verify that the right Media Guide is in the proper
Position. The media needs to be snug between the left
and right guides.
1. Verify Media is installed according to the Loading
Instructions.
2. Verify that the right Media Guide is in the proper
Position. The media needs to be snug between the left
and right guides.
3. Rewind the Media stock onto the supply roll until stock
is flat across the sensor.
1. Verify Media is installed according to the Loading
Instructions.
2. Run the Calibration Procedure.
1. Turn off the printer and remove the media.
2. Using a Swab dipped in Alcohol clean the Media
Sensor. See User's Manual for location of sensor.
1. Verify Media is installed under the media guides.
2. Verify that the right Media Guide is in the proper
Position. The media needs to be snug between the left
and right guides.
1. Verify that the width of the stock matches that of
previous roll. If not contact media supplier.
2. Verify that the label is centered properly on the
backing of the stock. If not contact media supplier.
Run Media Calibration procedure
1. Verify Media is installed under the media guides.
2. Verify that the right Media Guide is in the proper
Position. The media needs to be snug between the left
and right guides.
1. Turn off the printer and remove the media.
2. Using a Swab dipped in Alcohol clean the Media
Sensor. See User's Manual for location of sensor.
Verify that the stock matches that of previous roll. If not
contact media supplier.
74