Printing The Configuration Label; Figure 31 – Configuration Print Sample - AMT Datasouth Fastmark 600 Series User Manual

Printing the Configuration Label

1. Ensure the printer is powered off.
2. Make sure that Media width of 4 inches is installed and that the MEDIA WIDTH feature
is set for 4.00 inches.
3. Verify that the media is properly loaded and routed as detailed in Loading Media
Section.
4. While pressing and holding the FEED key, power on the printer.
5. When the printer begins to print the configuration label you may release the FEED key.
Note: The feature settings on your printer may vary based on any setup changes made or
firmware version installed in the printer.
When a PAL application is loaded into the printer the Print Sample will indicate this
on the Drive A or Drive B lines
Fastmark 600 Series User's Guide
Media Type
Media Sensing
Sensor Threshold
Media Length
Media Width
Present Distance
BackFeed Mode
Present Sensor
Cutter Mode
Vert Print Align
Horz Print Align
Vert Size Adjust
Print Darkness
Print Speed
Interface Select
COM1: Baud Rate
COM1: Parity
COM1: Data Bits
COM1: Handshake
COM1: PAL Xmit
Emulation Mode
Date
Time
Daylight Saving
Firmware Rev.
PAL Boot Drive
Max Media Length
Keypad Lockout
Label Count
Drive A: (131072)
Drive B: (262144)
Drive C: (0)
Drive D: (32768)
Figure 31 – Configuration Print Sample
Thermal Transfer
Gap
70
4.00 Inches
4.00 Inches
+0.24 Inches
Enable
Disabled
Disabled
0.00 Inches
+0.20 Inches
0
- 6
4
Auto Select
9600
None
8
RTS & XON
Disabled
PAL Emulation
Not Installed
Not Installed
Disabled
110156 A
Auto Detect
12.00 Inches
Disabled
582
Empty
Empty
Empty
Empty
33