Loading Media
1. Open the Top Media Access Cover by pressing in on both Cover locks (one on each side of
the printer) and lifting the top cover until it rests in the vertical position.
2. Spread the Media Holders apart and install the Media Roll onto the Media Roll Holder.
The Media Holders are spring loaded thus keeping the media centered into the printer.
Note 1: If the Media Core is 3 inches in diameter, insert the Media Core Adapter into the
media core.
Note 2: If feeding the media through the External Media Slot, install the Media Core
Adapter to hold the Media Roll Holders apart.
Media Roll
Fastmark 600 Series User's Guide
Figure 16 – Top Media Cover Latches
Figure 17 – Media Roll Installation
Cover Lock
Media Roll Holders
24