Table of Contents
Advertisement
MO
TU WE TH FR SA SU
I2:00
AM
PM
PROG A B C D
ROOM
70
°
Figure 2. Home Screen
At this point, the thermostat will be fully functional; its de-
fault temperature setpoint (not shown) is 70°F. At this
point, if the equipment has been fully powered and if a heat
demand were present, the system would begin operating.
NOTE − Temperature scale default is Fahrenheit units but
may be reset to show Celsius, if desired. See page 7.
Buttons, Backlight, Timers & Settings
Buttons are located behind the small door on the right−
hand side of the thermostat (see figure 3).
IMPORTANT
Do NOT begin pressing buttons until after you read
the following section describing each button.
A pale blue display backlight illuminates for 30 seconds
each time any button is pressed.
When PROG or DAY/TIME is pressed, a field begins flash-
ing, expecting another input. Start making changes within
15 seconds or the HOME screen will return.
505048M 08/07
MAINT
FILTER
SERVICE
FAN
ON
HOLD
AUTO
SYSTEM
COOL
OFF
HEAT
Figure 3. Thermostat Buttons
When an Arrow, HOLD, HEAT, or COOL button is pressed,
SETPOINT and the temperature setting appears for 15
seconds. If desired, start making changes within 15 sec-
onds or the HOME screen will return. The backlight will
turn off 15 seconds after the HOME screen reappears.
DAY/TIME − Setting the Day and Time
Press the DAY/TIME button and set the CURRENT hour,
minute, and day of week as follows:
1.
12" will flash on the screen. Press the UP/DOWN
AM
arrows to change the hour. ( AM" or PM" must corre-
spond to time of day.) Press DAY/TIME OR, if adjust-
ing for daylight savings time, pressing ENTER stores
the single change and exits to the HOME screen, by-
passing minutes and day of week.
2. Minutes will flash. Use the UP/DOWN arrow button to
display the minutes past the hour. Press DAY/TIME.
3. Day MO" (Monday) will flash. Use UP or DOWN arrow
buttons to display the current day. Day selections are
abbreviated as MO , TU", WE", TH", FR", SA",
and SU". Press DAY/TIME.
4. The HOME screen reappears; confirm day and time
are correct. This completes day and time setting.
Page 2
Heat
Cool
Prog
Day/Time
Fan
Hold
(DOOR
OPEN)
Settings
Enter
Hide quick links:
Advertisement
Table of Contents
