Dyna-Glo DGP350SNP User's Manual And Operating Instructions page 14

9. NOTE: Side Table Supports 1 (12) will be used for
9
both the right side front and left side rear placement.
Side Table Supports 2 (13) will be used for both the
right side rear and left side front placement.
Install the side table supports 1 (12) and side table
supports 2 (13) on both sides of the grill body with
12
screws (D). Arrows cut out of the supports indicate
13
the correct position of the support when fastened to
D
the grill body (9).
Hardware Used
D
x16
M5 x 12 Screw
9
10
WARNING: IT IS VERY IMPORTANT TO CHECK
AND ENSURE THAT EACH AND EVERY BURNER
IS FULLY ENGAGED WITH THE ADJACENT VALVE
ORIFICE BEFORE COMPLETING STEP 10. FAILURE
TO DO SO MAY
RESULT IN FIRE
14
OR EXPLOSION,
POSSIBLY CAUSING
SERIOUS INJURY
OR DEATH. REFER TO MAINTENANCE SECTION
INSTRUCTIONS TO PROPERLY CHECK THE
ENGAGEMENT.
10. Open the lid and place the two heat tents (14) on
the brackets directly above the burners.
12