Figure 23 - Feeding Into The Peeler Mechanism; Figure 24 - Backing Exit Position - AMT Datasouth Fastmark 600 Series User Manual

5. Position the Media Backing out of the printer and over the Peel Bar.
6. Push the Media Backing in the slot just under the Peel Bar and between the front cover.
Continue to push the stock until it comes out of the larger slot in the front cover.
7. If the Media Backing will not push through, then press the Feed button one time.
8. Once the media comes out of the larger slot, gently roll the excess media back onto the
Media Roll until the Backing is snug around the Peel Bar.
9. In this position the Media Backing coming out of the large slot in the front cover should
be aligned with the Labels coming out of the printer.
Note: If not, then pull down the Peeler Latch and gently pull the backing until they are aligned.
Make sure to close the Peeler Latch when done.
User Manual
Backing
Peeler Roller
Figure 23 – Feeding into the Peeler Mechanism
Figure 24 – Backing Exit Position
Label
Media Stock from Media Roll
Peeler Bar
Platen Roller
23