JVC XV-N50BK Service Manual page 10

XV-N50BK,XV-N55SL
2.1.5 Removing the rear panel (See Figure 8, Figure 9)
• Prior to performing the following procedure, remove the top
cover.
(1) Remove the eight screws E attaching the rear panel.
(2) Disconnect the power cord from connector P901 on the
power supply board
(3) Remove tie band.
2.1.6 Removing the servo control and signal output terminal board. (See Figure 9)
• Prior to performing the following procedure, remove the top
cover/rear panel.
(1) Remove the two screws F attaching the servo control and
signal output terminal board.
(2) Disconnect the card wire from connector CN101,CN502 on
the servo control and signal output terminal board.
(3) Disconnect the flat wire from connector CN902,CN903 on
the power supply board.
2.1.7 Removing the power supply board. (See Figure 9)
• Prior to performing the following procedure, remove the top
cover/rear panel.
(1) Remove the three screws G attaching the power supply
board.
(2) Disconnect the wire from connector CN901,CN902,
CN903,CN904 on the power supply board.
(3) Disconnect the socket wire from socket P901 on the power
supply board.
1-10 (No.A0041)
E
Fig.8
F F
CN101
CN502
CN902,CN903
Servo control and signal
output terminal board
Fig.9
Rear panel
E
E
G CN901
G
P901
G Power supply board