Connecting The Power Cord; Figure 4 - Power Connection - AMT Datasouth Fastmark 400 Series User Manual

Connecting the Power Cord

1. Make sure that the source voltage matches that on the input voltage on the power adapter.
Caution: Incorrect voltage could cause damage to the printer and/or the power
adapter.
2. Make sure that the power switch is set to the Off, "O", position.
3. Connect the power supply plug to the power jack on the printer.
Note: When plugging into the power jack, make sure that you avoid the 36 pin
parallel connector.
4. Connect the other end of the power adapter to your AC source.
User's Guide 10

Figure 4 - Power Connection