Loading Media When Cutter Is Equipped; Figure 13 - Loading Media - Cutter - AMT Datasouth Fastmark 400 Series User Manual

Loading Media When Cutter is Equipped

1. Follow the same procedure as "Loading Media".
2. After you thread the media over the platen roller, thread the media through the horizontal gap
at the cutter module.
Note: The printer must be configured for Peel and Present Mode. This setting may be made
in the windows driver, utility software, label design software or using printer
commands from the host.
Cutter
Caution: When removing a label from a printer with the Cutter option make
sure that the cutter is not rotating before removing the label or when
manually opening the printer.

Figure 13 - Loading Media - Cutter

User's Guide 19