Enabling The Speed Button; Disabling The Speed Button - Comdial HoTelephone 3809X User Manual

Programming (continued)
NOTE: A two-second pause is stored each time the
PAUSE control is
pressed. A fured 650 msec hookswitchflash signal is stored each
time the
TAP
control
is
pressed.
PAUSE and TAP
each equal
one
digit
in the 16-digit total.
5. Press STORE to end programming sequence. After the
16th digit is stored, the programming sequence will end
automatically. Success tone (beep) will sound to indicate
successful programming sequence.
6. Repeat steps 2-5 for each programmable button.
Enabling the SPEED Button
1. Press STORE, *, and lower right-hand programmable
button (Figure 2).
2. Press STORE again.
3. Label the programmable button "Speed."
Disabling the SPEED Button
l
Press STORE, #, SPEED, STORE.
Storin
by SP H
Numbers At Keypad Locations (to be accessed
ED button)
1. Lift handset.
2. Press STORE.
3. Dial speed location from keypad (O-9).
4. Dial number to be stored (16 digits maximum). If needed,
press TAP for a hookswitch flash signal and PAUSE for a
pause between numbers. A valid entry causes an acknow-
ledge tone or a click to sound from the handset receiver.
An invalid entry causes an error tone or a buzz to sound.
5. Press STORE to end programming sequence. After the
16th digit is stored, the programming sequence will end
automatically. Success tone (beep) will sound to indicate
successful programming sequence.
6. Repeat steps 2-5 for each speed dial location.
Continued on next page...