Replacing The Fuse - Yamaha Giggle XF50E Owner's Manual

Fuse, replacing<IXE>
place it in a cool, dry place. NO-
TICE: When removing the battery,
be sure the key is turned to
"OFF", then disconnect the
negative lead before disconnect-
ing the positive lead.
2. If the battery will be stored for more
than two months, check it at least
once a month and fully charge it if
necessary.
3. Fully charge the battery before in-
stallation.
4. Before installation, make sure that
the battery leads are properly con-
nected to the battery terminals.
NOTICE
8 8 8 8 8 Always keep the battery charged.
Storing a discharged battery can
cause permanent battery dam-
age.
8 8 8 8 8 After installing the battery, be
sure to turn the main switch from
"ON" to "OFF" three times in 3
seconds intervals to initialize the
idle speed control system.
PERIODIC MAINTENANCE AND ADJUSTMENT

Replacing the fuse

[ECA16302]
ZAUM00**
1. Fuse
The fuse holder is located beside the
battery. Remove panel C to access the
ECAT1053
fuse. (See page 6-6.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not use
a fuse of a higher amperage rat-
ing than recommended to avoid
causing extensive damage to the
EAUT2023
1
3. Turn the key to "ON" and turn on
4. If the fuse immediately blows again,
6-55 6-20
electrical system and possibly a
fire.
[EWA15131]
NOTICE: After removing and in-
stalling the main fuse, be sure to
turn the main switch from "ON"
to "OFF" three times in 3 seconds
intervals to initialize the idle
speed control system.
Specified fuse:
15 A
the electrical circuits to check if the
devices operate.
have a Yamaha dealer check the
electrical system.
EAU1722A
1
2
[ECAT1062]
3
4
5
6
7
8
9