Configure Wpa-Personal (Psk) - D-Link GO-RT-N150 User Manual

Section 4 - Security
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the
added overhead.
1. Log into the web-based configuration by opening a web browser
and entering the IP address of the router (192.168.0.1). Click on
Setup and then click Wireless Settings on the left side and then
click Manual Wireless Network Setup.
2. Next to Security Mode, select WPA/WPA2.
3. Next to Cypher Type, select AUTO(TKIP/AES) TKIP, or AES. If you
have wireless clients that use both types, use AUTO(TKIP/AES).
4. Next to Pre-Shared Key, enter a key (passphrase). The key is entered
as a pass-phrase in ASCII format at both ends of the wireless
connection. The pass-phrase must be between 8-63 characters.
5. Click Save Settings to save your settings. If you are configuring the
router with a wireless adapter, you will lose connectivity until you
enable WPA-PSK on your adapter and enter the same passphrase
as you did on the router.
D-Link GO-RT-N150 User Manual

Configure WPA-Personal (PSK)

50