Pppoe (Dsl) - D-Link N300 User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through a router.
My Internet Select PPPoE.(Username/Password) from the drop-down menu.
Connection:
Enable Advanced Domain Name System (DNS) services enhances your Internet
Advanced DNS
performance by getting you the information and web pages you are looking
Service: for faster and more reliably. In addition, it improves your overall Internet
experience by correcting many common typo mistakes automatically, taking
you where you intended to go and saving you valuable time.
Disclaimer: D-Link makes no warranty as to the availability, reliability, functionality
and operation of the Advanced DNS service or its features.
Enable True Check to enable true Gigabit routing. This will increase the through-put of
Gigabit Routing
the WAN-LAN connectivity of the router.
Connectivity:
Address Mode: Select Static.IP if your ISP assigned you the IP address, subnet mask, gateway,
and DNS server addresses. In most cases, select Dynamic.
IP Address:
Enter the IP address (Static PPPoE only).
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype the password in the next box.
Service Name:
Enter the ISP Service Name (optional).
Reconnect Select either Always-on, On-Demand, or Manual.
Mode:
D-Link DIR-636L User Manual
Internet Setup

PPPoE (DSL)

31