Harman Kardon HKTS 9 Owner's Manual page 9

HKTS 9/16
Front left Speaker Cable (White Bands)
FRONT
+ –
RIGHT
LEFT
+ – + –
Receiver
Surround left Speaker
Cable (Blue Bands)
Connecting the Subwoofer to a Receiver or Preamp/Processor with
Line Outputs
Use this installation method for receivers and preamp/processors that do not have a
dedicated subwoofer output but do have preamp-level (volume-controlled) line outputs.
If the receiver or preamp/processor has a dedicated subwoofer output with low-pass
filtering, see Connecting the Subwoofer to a Receiver or Preamp/Processor with a
Dedicated Subwoofer Output, on page 8.
Center Speaker Cable (green Bands)
SURROUND CENTER
+ –
LINE-LEVEL
OUTPUTS
L R
Surround Right Speaker Cable (gray Bands)
Front Right Speaker Cable (Red Bands)
Set Input Mode Switch
to "normal"
Stereo Audio Cable (not
supplied, Red and White ends)
If you're connecting to a receiver with left and right line outputs, connect the lFe (purple)
connector of the supplied combination lFe and trigger cable to one of those outputs and
to either of the HKTS 210SUB's Line-Level L/R In connectors 7. Use a second RCA
cable (not supplied) to connect the other receiver or preamp line output to the other of
the HKTS 210SUB's Line-Level L/R In connectors 7. Set the subwoofer's Input Mode
switch 4 in the "normal" position.
Connect each satellite speaker and the center speaker to the corresponding speaker
terminals on your receiver or amplifier.
After you have made and verified all connections, plug the HKTS 210SUB's AC Power
cord 9 into an active AC outlet.
Speaker Connections
Subwoofer
9