Mounting Options - Harman Kardon HKTS 9 Owner's Manual

HKTS 9/16
3. Bring the speaker cable through the wall-bracket attachment plate, and mount the
attachment plate on the wall in the desired location.
Bring Speaker Cable
Through Opening
4. Thread the speaker cable through the arc-shaped opening on the top of the
mounting bracket, not the screw hole.
Bring Speaker
Cable Through Arc-
Shaped Opening
Overhead View
5. Attach the mounting bracket to the wall plate by inserting the tab at the top of the
attachment plate into the slot on top of the bracket and snapping the bracket onto
the attachment plate.
Insert Tab into Slot and
Snap Bracket onto Plate
6. Fit the terminal cover onto the bracket as shown in the illustration
connect the speaker leads to the terminals on the underside of the speaker.
Remember to observe the correct polarity.
Terminal Cover
Mounting Bracket
Side View
7. Fit the terminal cover into the opening on the underside of the speaker so that it is
flush against the speaker and covers the terminals. Insert the supplied long bracket
bolt up through the bottom of the bracket and terminal cover, and screw it into the
threaded insert on the underside of the speaker. The bolt should be snug but not so
tight as to prevent the speaker from pivoting on the bracket.
Attach Speaker to
Bracket Using long Bolt
you can pivot the wall-mounted speaker from side to side; however, attempting to tilt it
up or down will damage the bracket and possibly the wall, which would not be covered
by your warranty.
Cable to Speaker
Cable from
Wall Plate
Side View
Feed Cable Through Mount
and out of Opening
below, then
Connect Cable leads
to Speaker Terminals
Fit Terminal Cover
into Recess on
Speaker Bottom
Wall-Mounting the Center Speaker
1. Determine the location for the speaker. If possible, position the speaker so that one
of the mounting screws (not included; use size #10) can be installed directly into a
wall stud. If that is not possible, use optional wall anchors that are rated to support
at least 25 lb (11.3kg) and are appropriate for the construction and materials of
your wall. The customer is responsible for the proper selection and use of
mounting hardware, available through hardware stores, to wall-mount the
speaker properly and safely.
2. Bring the speaker cable through the wall-bracket attachment plate as shown, and
mount the attachment plate on the wall in the desired location.
Bring Cable Through Opening
3. Remove the rubber pads from the foot rests on the bottom of the center speaker
and connect the speaker leads to the terminals on the underside of the speaker.
Remember to observe the correct polarity.
Connect Cable
4. Use the supplied screws to attach the speaker to the wall-mount bracket. The
screws thread into the center foot-rest openings that were exposed when you
removed the rubber pads in the previous step.
Use Supplied Screws to
Attach Speaker to Bracket

Mounting Options

Use Mounting Hardware Appropriate
for Wall Construction and Materials
Remove Pads
Thread Screws into
Center Openings
7