Radio - Sharp XL-UH4H Operation Manual

Using the Radio Data System (RDS) (continued)
XL-UH4H
To show Radio Data System signals on display
Select an FM station with Radio Data System signals.
1
Press the TUNER (BAND) button to select the FM.
2
Press the RDS DISPLAY button on the remote control.
The display will switch as follows:
PS (Programme Service):
Whilst searching, "PS" alternately appear on the display.
Then, the station name appears. "NO PS" appears if no signal is
sent.
PT (Programme Type):
Whilst searching, "PTY" alternately appear on the display.
Then, the broadcast programme type appears. "NO PTY" appears
if no signal is sent.
RT (Radio Text):
Whilst searching, "RT" alternately appear on the display.
Then, the next message sent by the station appears. "NO RT"
appears if no signal is sent.
Station Frequency:
The frequency of the selected station appears on the display.
32
PS PTY RT
Station Frequency
To recall stations in memory
To specify programmed types and select stations (PTY search):
You can search a station by specifying the programme type (news,
sports, traffic programme, etc. ... see pages 33 - 34) from the stations
in memory.
1
Press the TUNER (BAND) button to select the FM.
2
Press the RDS (ASPM/PTY) button on the remote control.
"SEL PTY" (blinking) will appear for about 6 seconds.
3
Within 6 seconds, press the PRESET (
lect the PTY code.
Each time the button is pressed, the PTY code will appear. If
the button is held down for more than 0.5 seconds, the PTY
code will appear continuously.
4
Whilst the selected PTY code is displayed (within 6 sec-
onds), press the RDS (ASPM/PTY) button again.
The unit searches the 20 preset stations and stops when it finds
a station of the selected category then tunes into the station. The
RDS indicator lights up.
If no programme is found in the 20 preset stations, "NO PTY"
appear on the display and returns to the previous station.
or ) button to se-
RDS
MHz