Table of Contents
Advertisement
Hardware Setup
Warning: Follow these precautions to preserve your
Motherboard from any remnant currents when connecting
to ATX power supply:
Turn off the power supply and unplug the power cord
of the ATX power supply before connecting to ATX PW
connector.
The Motherboard requires a power supply with at least 200 Watts
and a "power good" signal. Make sure the ATX power supply can
take at least 10 mA* load on the 5V Standby lead (5VSB) to meet
the standard ATX specification.
* Note: If you use the Wake-On-LAN (WOL) function, make
sure the ATX power supply can support at least 720 mA on the
5V Standby lead (5VSB).
Please install the ATX power according to the following pin
assignment:
ATX Power
12V
5V
5VSB
5V
PW-0K
-5V
GND
GND
5V
GND
GND
GND
5V
PS-ON
GND
GND
3.3V
-12V
3.3V
3.3V
Ø
Pay special care to the directionality.
21
SY-D6IBA
Advertisement
Table of Contents
