Table of Contents
Advertisement
Hardware Setup
SY-D6IBA
Please install according to the following pin assignment:
Wake-On-LAN
JP44 Pin Assignment
MP - Wake-up
GND
5VSB
1 2 3
2. Infrared (IR1)
Plug the 5-pin infrared device cable to the IR1 header. This will
enable the infrared transfer function. This Motherboard meets both
the ASKIR and HPSIR specifications.
Please install according to the following pin assignment:
Infrared (IR) Connector
IR1 Pin Assignment
VCC
IRRX GND
IRTX
1
2
3
4
5
Step 9. Cooling Fan Installation
1. CPU Cooling Fans (FAN 1, FAN 2)
After you have seated the Single or Dual CPU properly on the
Motherboard, attach the 3-pin fan cable from each CPU to the
corresponding CPUFAN connector FAN 1 or FAN 2 on the
Motherboard.
The CPU fans will stop when the system enters into Suspend Mode.
(Suspend mode can be enabled from the BIOS Setup Utility,
[POWER MANAGEMENT] menu.)
18
Advertisement
Table of Contents
