Toshiba MMK-AP0074MH-TR Owner's Manual page 13

SMMS High-Wall Type
Names and functions of
indications on wireless remote
controller
Display
All indications, except for clock time indication, are
indicated by pushing the START / STOP button.
3 1 2
AUTOA
8 6 4
• In the illustration, all indications are indicated for
explanation. During operation, only the relevant
indications will be indicated on the remote
controller.
1
Transmission mark
This transmission mark (
remote control transmits signals to the indoor unit.
2
Mode display
Indicates the current operation mode.
(AUTO: Automatic control, A: Auto changeover
control, : Cool,
only)
3
Temperature display
Indicates the temperature setting (17 °C to 30 °C).
When the operation mode is set to
temperature setting is indicated.
4
FAN speed display
Indicates the selected fan speed. AUTO or one of five
fan speed levels (LOW
+
MED , MED
HIGH ) can be indicated.
Indicates when the operation mode is
Dry.
5
TIMER and clock time display
The time set for timer operation or clock time is
indicated.
The present time is always indicated except for
TIMER operation.
6
Hi POWER display
Indicates when the Hi POWER operation starts.
Push the Hi-POWER button to start and push it again
to stop the operation.
7
(MEMORY) display
Flashes for 3 seconds when the MEMO button is
pushed during operation.
mark is indicated when the button is not pushed
for more than 3 seconds while the mark is flashing.
Push another button to turn off the mark.
7
A
B
5
) indicates when the
: Dry, : Heat, : Fan
: Fan only, no
+
, LOW ,
,
:
8
ECO TIMER display
Indicates when the ECO TIMER is in operation.
Each time the ECO button is pushed, the display
changes in the sequence of 1, 3, 5 or 9 h.
AUTO
NOTE
When both wired remote controller and wireless
remote controller are used, display on the screen of
wireless remote controller may differ from the
actual operation in some cases.
– 12 –
Owner's Manual
A
B
EN
12-EN