GE KTD-405 User Manual page 29

Entering a new preset number or pressing
8. To change key assignments, press the + side
of the zoom, focus, or iris keys.
9. At the PRESS KEY TO PROGRAM display
(Figure 24), press any of the available
reprogrammable keys. You can also program
the shifted keys by holding the esc key and
pressing the key. (See
and commands on page 67.)
10. At the command selection display, use the joystick (or the
through the list of commands until you find the desired command. The commands are listed in
alphabetical order. Then press the
reprogrammed soft key.
Note: Pressing the key returns you to the PRESS KEY TO PROGRAM display.
11. At the PRESS KEY TO PROGRAM display
(Figure 24), press any of the available
reprogrammable keys. (See
Reprogrammable keys and commands
page 67.)
12. At the CONFIRM COMMAND SELECTON
display, press the + side of the zoom, focus,
or iris key to confirm the assignment of the
command for the key or press
the PRESS KEY TO PROGRAM display.
13. The KEY HAS BEEN PROGRAMMED display flashes briefly, then the PRESS KEY TO PROGRAM
display (Figure 24) returns. If you want to reprogram additional keys, repeat the process from step 4.
Reprogrammable keys
key ( on the display) to save the selected command for the
on
to return to
will take you to the display shown in Figure 23.
Figure 23. PROGRAM SOFT KEYS display
PROGRAM SOFT KEYS?
_
Figure 24. PRESS KEY TO PROGRAM display
PRESS KEY TO
PROGRAM:
and
Figure 25. Command selection display
SLW/STOP
STABILIZ
Figure 26. Confirm command selection display
SLW/STOP
STABILIZ?
Programming
keys) to scroll up and down
-
-
Chapter 3 25