Table of Contents
Advertisement
M F6 SET:
When you press [F6] an OSD configuration submenu. To change a setting,
move the highlight bar to the choice you want, then press [Enter]. On the
submenu that appears next, move the highlight bar to the choice you want and
press [Enter]. An icon of a pointing finger indicates which choice is the currently
selected one. An explanation of the choices is given in the table, below:
Setting
CHANNEL
DISPLAY
DURATION
CHANNEL
DISPLAY
POSITION
CHANNEL
DISPLAY MODE
SCAN
DURATION
CLEAR THE
NAME LIST
(Table continues on next page)
22
Determines how long a Port ID is displayed for. There are two
choices: 3 Seconds - which displays the Port ID for 3 seconds
after a port change has taken place; and Always On - which
displays the Port ID at all times.
Allows you to position where the Port ID is shown on the screen.
After you highlight this item and press [Enter], the menu
disappears and the Port ID is displayed. Use the Arrow Keys, Pg
Up, Pg Dn, Home, End, and 5 (on the numeric keypad with Num
Lock off), to position the Port ID display, then press [Enter] to
lock the position and return to the Set submenu.
Selects how the Port ID is displayed. There are three choices:
PN + NAME (the Number plus the Name); PN (the Number
alone); or NAME (the Name alone).
Determines how long the display dwells on each port when it
cycles through the selected ports in Quick View Scan Mode. The
available options are: 3, 5, 10, 15, 20, 30, 40, and 60 seconds.
Clears all Port Names from the Name List. You are asked to
confirm before the procedure goes on. Key in Y, then press
[Enter] to confirm. While the names are being cleared, a
message appears on the display to indicate so. After the names
have been cleared, another message appears to indicate that the
procedure completed successfully seconds.
Function
CS-138A User Manual
Advertisement
Table of Contents
