Charging An Empty Battery - Husqvarna Robotic Lawn Mower Operator's Manual

Charging an empty battery

These instructions apply when Auto Mower is new, or after a long period of storage.
If the Auto Mower has been used recently it does not need to be started in the charging station, see the chapter "Start and stop".
Place the Auto Mower in the charging
station for 60 minutes
The charging pins must be in contact with the
charging station contact plates. Set the Auto
Mower power switch to "STOP" for the battery to
be charged gently.
Set the power switch to on
The beep indicates that the battery has enough
power to run the electronics.
Enter code ( code #)
*
A short beep is heard and LED 1 lights each
time a button on the keypad is pressed.
Code accepted
A short beep is heard and LED 1 lights on the
keypad. Lower the cover.
Auto Mower continues to charge
Auto Mower signals 2 beeps/10 seconds (LED 1
flashes) and starts as soon as the battery is fully
charged.
Note the battery is not charged on delivery. The
battery is now charged using a considerably
higher current than during trickle charging. It
normally takes 3-8 hours to charge an
uncharged battery for the first time. When the
battery is fully charged the Auto Mower will begin
mowing automatically.
12
– English
USE
Incorrect entry
A long beep is heard and LED 6 flashes. OR
Incorrect code
A long beep is heard and LED 6 flashes. The
keypad is now switched off. You must wait 2
minutes before making a new attempt.
Contact your dealer if you have lost your
code.