Ford Fiesta Owner's Handbook Manual page 142

I
H
G
E102881
A Label
B Sealant bottle
C Sealant bottle hose
D Bottle holder
E Pressure gauge
F Power plug with cable
G Compressor switch
H Repair kit hose
I Pressure relief valve
1. Remove the tyre repair kit from the
wrapping.
Wheels and tyres
A
B
C
D
E
F
140
2. Peel off the label A showing the
maximum permissible speed of
80 km/h (50 mph) from the sealant
bottle and attach it to the instrument
panel in the driver's field of view. Make
sure the label does not obscure
anything important.
3. Take the hose H with the pressure
relieve valve I and the power plug with
cable F out of the kit.
4. Connect the hose H with the pressure
relieve valve I to the sealant bottle B.
5. Engage the sealant bottle B into the
bottle holder D.
6. Remove the valve cap from the
damaged tyre.
7. Screw the sealant bottle hose C firmly
onto the valve of the damaged tyre.
8. Make sure that the compressor switch
G is in position 0.
9. Insert the power plug F into the cigar
lighter socket or auxiliary power
socket. See Cigar lighter (page 80).
10. Start the engine.
11. Move the compressor switch G to
position 1.
12. Inflate the tyre for no longer than 10
minutes to an inflation pressure of
minimum 1.8 bar (26 psi) and a
maximum of 3.5 bar (51 psi). Move
the compressor switch G to position
0 and check the current tyre
pressure with pressure gauge E.
Note: If a tyre pressure of 1.8 bar (26 psi)
is not reached do not continue.
Note: When pumping in the sealant
through the tyre valve, the pressure may
rise up to 6 bar (87 psi) but will drop again
after about 30 seconds.
13. Remove the power plug F from the
cigar lighter socket or auxiliary power
socket.