Ford F-650 2015 Owner's Manual page 233

232
Replacing Front Parking, Turn Signal and Side Marker Lamp Bulbs
To remove the parking lamp and turn signal bulbs:
4. Carefully pull the bulb straight out of the socket.
5. Reverse the procedure to install the new bulb.
Replacing Front Clearance and Identification Lamp Bulbs
2015 F-650/750 (f67)
Owners Guide gf, 2nd Printing, April 2014
USA (fus)
Maintenance
3. Remove the four screws and the
retaining bracket from the headlamp
bulb.
4. Pull the headlamp bulb out of the
housing. Disconnect the electrical
connector, and then remove the
headlamp bulb.
5. Reverse the procedure to install
the new bulb.
1. Make sure the headlamp control
is in the off position and the
turn signals are off.
2. Remove the four screws from
the lamp assembly.
3. Carefully lower the lamp
assembly and pull the bulb
socket straight out of the lamp
assembly.
1. Make sure the headlamp control
is in the off position.
2. Remove the screw and lens from
the lamp assembly.
3. Pull the bulb straight out of the
socket.
4. Reverse the procedure to install
the new bulb.