Ford F-650 2015 Owner's Manual page 223

222
6. Reinstall rubber diaphragm and cap onto reservoir.
See the Scheduled Maintenance chapter for service intervals.
Clutch Linkage
Lubricate the clutch linkage using the following procedure. Use a grease
that meets manufacturer specifications. See the Capacities and
Specifications chapter.
Transmission and clutch removed for clarity.
5. Reinstall the inspection cover.
See the Scheduled Maintenance chapter for service intervals.
2015 F-650/750 (f67)
Owners Guide gf, 2nd Printing, April 2014
USA (fus)
Maintenance
1. Set the parking brake, shift into
first gear and turn the engine
off.
2. Open the hood.
3. Clean the reservoir cap before
removal to prevent dirt and
water from entering the
reservoir.
4. Remove cap and rubber
diaphragm from reservoir.
5. Add fluid, if necessary, until it
reaches the step in the reservoir.
1. Set the parking brake, shift into
first gear and turn the engine
off.
2. Remove the inspection cover
from the clutch housing.
3. Lubricate the clutch release
bearing (one location) and the
clutch release shaft (two
locations) grease fittings with a
grease gun.
4. Lubricate the clutch release
wear pads (two locations) where
they contact the clutch release
bearing with a brush or similar
tool.