Husqvarna LGT2554 Owner's Manual page 8

• ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower
and position slot in link assembly over pin on rear mower
bracket (D) and secure with washer and retainer spring.
• Repeat on opposite side of tractor.
• Turn steering wheel to position wheels straight forward.
• ATTACH FRONT LINK (E) - Work from left side of tractor.
Insert rod end of link assembly through front hole in trac-
tor front suspension bracket (F) and secure with retainer
spring (G) through hole in link located behind the bracket.
• Insert other end of link (E) into hole in front mower bracket
(H) and secure with washer and retainer spring (J).
F
G
K
ASSEMBLY
C
D
Fig. 9
E
H
Fig. 10
L
S
C
D
• Disengage belt tension rod (K) from locking bracket (L).
• Install belt onto engine clutch pulley (M).
IMPORTANT: Check belt for proper routing in all mower
pulley grooves.
•
Engage belt tension rod (K) on locking bracket (L).
CAUTION: Belt tension rod is spring
loaded. Have a tight grip on rod and
engage slowly.
• Raise attachment lift lever to highest position.
• If necessary, adjust gauge wheels before op er at ing
mower as shown in the Operation section of this
manual.
MOWER DRIVE BELT INSTALLATION
J
Follow procedure described in "TO REPLACE MOWER
BLADE DRIVE BELT " in the "Service and Adjustments"
section of this manual.
B
M
A
C
D
Fig. 12
8
M
Fig. 11
F
E
H