Power Saving Mode; Self Clean Operation Mode - Toshiba RAV-SM566KRT-E Owner's Manual

5-3. Power saving mode

The power saving mode saves energy by limiting the maximum current which will effect heating or cooling capacity
that the unit can generate.
Push button during operation.
• The air conditioner enters power saving mode.
• appears on the display.
Power saving mode will stay in effect until it is cancelled.
To cancel the power saving mode, push
• disappears.
To configure the power saving mode settings
When RAV-SP***2AT / RAV-SM***3AT or older is used, the displayed setting changes, but the actual power level
is always "75 %".
5 4 2
1
Push button for at least four seconds
when the air conditioner is not working.
, symbol, and numbers flash.
2
Push (left side of the button) to select
an indoor unit to be set.
Each time the button is pushed, UNIT No. change
as follows:
UNIT No. UNIT No. UNIT No.
1-1 1-2 1-3
UNIT No.
1-4
The fan of the selected unit runs.
29-EN
button again.
3
Push TIME buttons, to adjust the
power saving mode setting.
• Each push of the button changes the power
level by 1 % within the range from 100 % to 50
1
%.
• The factory default is 75 %.
3
Setting of power level in
power saving mode
4
Push button.
5
Push button to complete the setting.
NOTE
• When other electric appliances are used at the same
time, to avoid triggering the circuit breaker, power
saving mode is recommended. Of course power
saving mode can be used to save energy as well.
• Power saving mode consumes less energy, but may
not heat / cool the room as much as normal mode.
(The maximum current is limited to approximately 75
% (factory default) of the normal mode.)
• To adjust the power-save settings, see "To configure
the power saving mode settings" in Power saving
mode.
• Even when operation start / stop, operation mode
change, or power reset is performed during the power
saving mode, the power saving mode is retained until
the next operation.
– 15 –

5-4. Self clean operation mode

This function is provided to dry the inside of the indoor unit by the FAN operation after running the cooling
/ dry / Auto (cooling) mode to keep the indoor unit clean.
• The self clean operation time varies with the cooling / dry / AUTO (cooling) operation time as follows.
Cooling / dry / AUTO (cooling) operation time
Less than 10 minutes
10 minutes to less than 1 hour
More than 1 hour
• " " is displayed on the remote controller during self clean operation.
To stop self clean operation forcibly, push
CAUTION
• The fan continues to run even after
This is normal because the self clean operation mode is in progress.
• The louvers open slightly and are directed horizontally during self clean operation, and they close when the self clean
operation is completed.
• The operation lamp (LED) does not light during the self clean operation mode (function).
• The self clean operation mode (function) cannot clean the room or remove the already existing mold and dust inside
the indoor unit.
• To cancel the self clean operation function, consult the dealer.
Self clean operation time
No self clean operation
1 hour
2 hours
button twice in succession.
button is pushed to stop operation in some modes.
30-EN