Handling The Remote Controller; How To Use Remote Controller - Toshiba RAV-SM566KRT-E Owner's Manual

4-3. Handling the remote
controller
CAUTION
• The air conditioner will not operate if curtains, doors or
other materials block the signals from the remote
controller to the indoor unit.
• Prevent any liquid from falling into the remote
controller.
Do not expose the remote controller to direct sunlight
or heat.
• If the infrared signal receiver on the indoor unit is
exposed to direct sunlight, the air conditioner may not
function properly.
Use curtains to prevent the sunlight from reaching the
receiver.
• If the room using the air conditioner has fluorescent
lighting with electronic starters, signals may not be
properly received. If you are planning to use such
fluorescent lamps, consult your local dealer.
• If other electrical appliances react to the remote
controller move these appliances or consult your local
dealer.
Location of the remote
controller
• Keep the remote controller where its signals can
reach the receiver of the indoor unit (a distance of 7
m is allowed).
• When you select the timer operation, the remote
controller automatically transmits a signal to the
indoor unit at the specified time.
If you keep the remote controller in a position that
hinders proper signal transmission, a time lag of up
to 15 minutes may occur.
7 m
15-EN
Remote controller holder
◆ Installing the remote controller
holder
Before you actually install the remote controller holder
on a wall or pillar, check whether the remote controller
signals can be received by the indoor unit.
◆ Mounting and removing the
remote controller
To mount the remote controller hold it parallel to the
remote controller holder and push it in fully. To remove
the remote controller slide the remote controller
upwards and out from the holder.
4-4. How to use remote
controller
Cooling / heating / fan only
operation
◆ Start
3
PRESET FAN 4
TEMP
1
MODE
2
1
START/STOP button ( )
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select Cool , Heat , or Fan only
3
Temperature button ( )
TEMP
Set the desired temperature.
When the air conditioner is in FAN ONLY
operation, the temperature display is not
indicated.
4
Fan speed button (FAN)
+
Select one of LOW , LOW
+
MED , MED , HIGH
• The OPERATION lamp (green) on the display
panel of the indoor unit goes on. And operation starts
after approximately 3 minutes.
(If you select FAN ONLY mode, the unit will start
immediately.)
• The : Fan only mode does not control
temperature.
• Fan speed is the same as HIGH
Therefore, perform only steps 1 , 2 and
this mode.
◆ Stop
START/STOP button ( )
Press this button again to stop the air conditioner.
– 8 –
Dry operation
◆ Start
PRESET FAN
TEMP
MODE
1
START/STOP button ( )
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select DRY .
3
Temperature button ( )
TEMP
Set the desired temperature.
• The fan speed display indicates
.
• The OPERATION lamp (green) on the display
panel of the indoor unit lights, and operation starts
after approximately 3 minutes.
◆ Stop
START/STOP button ( )
Press this button again to stop the air conditioner.
,
.
.
4 to select
3
1
2
EN
16-EN