Table of Contents
Advertisement
6
Power saving mode
The power saving mode saves energy by limiting the maximum current which will effect heating or cooling capacity
that the unit can generate.
Push
button during operation.
• The air conditioner enters power saving mode.
•
appears on the display.
Power saving mode will stay in effect until it is cancelled.
To cancel the power saving mode, push
disappears.
■
To confi gure the power saving settings
5
1
Push
button for at least 4 seconds when the air conditioner is not working.
flashes.
2
Push
(left side of the button) to select an indoor unit to be set.
• Each time the button is pushed, UNIT No. change as follows:
UNIT No.
UNIT No.
UNIT No.
1-1
1-2
1-3
UNIT No.
1-4
The fan of the selected unit runs.
3
Push
buttons, to adjust the setting of power level.
• Each push of the button changes the power level by 1% within the range from 100% to 50%.
• The factory default is 75%.
Setting of power level in power
saving mode
19-EN
button again.
1
3
4
2
4
Push
button.
5
Push
button to complete the setting.
NOTE
• When other electric appliances are used at the same time, to avoid triggering the circuit breaker, power saving
mode is recommended. Of course you can use power saving mode to save energy as well.
• Power saving mode consumes less energy, but may not heat / cool the room as much as normal mode.
(The maximum current is limited to approximately 75% (factory default) of the normal mode.)
• To adjust the power-save settings, see "To configure the power saving settings" in Power saving mode.
• Even when operation start / stop, operation mode change, or power reset is performed during the power saving
mode, the power saving mode is retained until the next operation.
– 10 –
20-EN
Advertisement
Table of Contents
