Wired Remote Controller - Toshiba RAV-SM566KRT-E Owner's Manual

5

Wired remote controller

This remote controller can control the operation of up to 8 indoor units.
Display section
In the display illustration below all the icons are shown. When the unit is in
operation, only relevant icons will be displayed.
• When the leak breaker is turned on at the first time,
display part of the remote controller.
• While this icon is flashing, the model is being automatically confirmed.
Wait till icon has disappeared to use the remote controller.
3
1
2
5
6
7
19
1
Operation mode
The selected operation mode is displayed.
2
Error display
Displayed while the protective device works or a
error occurs.
3
SETTING display
Displayed during setup of the timer or other
settings.
4
TEST run display
Displayed during a test run.
5
Timer display
When an error occurs, error code is displayed.
6
Timer mode display
The selected timer mode is displayed.
7
Filter display
Reminder to clean the air filter.
8
Louver position display
Displays louver position.
23-EN
flashes on the
TEMP. ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
13
14 18
12
4 8 9
11
15
16
10
17
9
SWING display
Displayed during up / down movement of the
louver.
10
Fan speed display
The selected fan speed mode is displayed.
(AUTO)
(HIGH)
(MED.)
(LOW)
11
Set temperature display
The selected set temperature is displayed.
12
Power saving mode display
Limits compressor speed (capacity) to save
energy.
1
2
5
Display
section
6
7
Operation
19
section
13
UNIT No. display
Displays the number of the indoor unit selected.
Also displays error code of indoor and outdoor
units.
14
Central control display
Displayed when the air conditioner is used under
the central control in combination with a central
control remote controller.
In case the remote controller is disabled by the
central control system,
20
The button operation is not accepted.
Even when ON / OFF, MODE, or TEMP. button is
pushed, and the button operation is not accepted.
(Settings made by the remote controller vary with
the central control mode. For details, refer to the
Owner's Manual of the central control remote
controller.)
15
Remote controller sensor display
Displayed while the sensor of the remote controller
is used.
16
Pre-heat display
Displayed when the heating mode is energized
or defrost cycle is initiated.
While this icon is displayed, the indoor fan stops.
17
No function display
Displayed when the function requested is not
available on that model.
18
Self clean operation display
Displayed during self clean operation.
19
Service display
20
Operation ready display
This display appears on some models.
– 12 –
13
14 18
3 4 8 9 12
10
flashes.
11
15
20
16
17
EN
24-EN