About Bluetooth Icons; Connection; To Switch The Bluetooth Signal Output Of This Unit To On; Connecting A Cellular Phone - Sony MEX-BT2900 Operating Instructions Manual

•
18
About Bluetooth icons
The following icons are used by this unit.
Lit: Bluetooth signal is on.
0 Flashing: Pairing is in standby mode.
None:
Bluetooth signal is off.
Lit: Connected to a cellular
phone.
~~
Flashing: Connection is in progress.
None: No cellular phone is
connected for handsfree
calling.
Lit: Connected to a device.
~~
Flashing: Connection is in progress.
None: No device is connected for
music streaming.
Lit: Some unread SMS
messages exist.
~
Flashing: A new SMS message has
been received.
None: No unread SMS messages
exist.
Signal strength status of
T....
connected cellular phone.
*
Remaining battery status of
~
...
:
connected cellular phone.
*
*
Turns off without handsfree connection. Differs in the
case of
a
cellular phone.
Connection
If pairing has already been achieved, start
operation from here.
To switch the Bluetooth signal
output of this unit to on
To use the Bluetooth function, switch the
Bluetooth signal output of this unit to on.
1
Press @).
Bluetooth signal is activated.
Connecting a cellular phone
1
Be sure that both this unit and the
cellular phone are switched to
Bluetooth signal on.
2
Connect to this unit using the cellular
phone.
"iii"
"appears when the connection is made.
If you select the Bluetooth Phone source after
the connection is made, the network name
and the connected cellular phone name
appear in the display. To change display
items, press
(DSPL).
Connecting the last-connected
cellular phone from this unit
1 Be sure the cellular phone is switched to
Bluetooth signal on.
2 Press
(SOURCE/OFF)
repeatedly until "BT
PHONE" appears.
3 Press \. (handsfree).
"~""
flashes while the connection is being
made.
"~""
stays lit when the connection is
made.
Notes
• Some cellular phones require permission to access
their phonebook data during handsfree connection
to this unit. Obtain permission via the cellular phone.
• While streaming Bluetooth audio, you cannot
connect from this unit to the cellular phone. Connect
from the cellular phone to this unit instead. A
connecting noise may be heard over playback
sound.
Tips
• With Bluetooth signal on: when the ignition is turned
to on, this unit reconnects automatically to the last-
connected cellular phone. But automatic connection
also depends on the cellular phone's specification.
If
automatic connection is not made, connect
manually.
• You can also select the Bluetooth Phone source by
press
(CALL).
Connecting an audio device
1
Be sure that both this unit and the
audio device are switched to
Bluetooth signal on.
2
Connect to this unit using the audio
device.
"~""
appears when the connection is made.
Connecting the last-connected audio
device from this unit
1 Be sure the audio device is switched to
Bluetooth signal on.
2 Press
(SOURCE/OFF)
repeatedly until "BT
AUDIO" appears.