The Door Has Not Been Opened After Two Complete Wash; Open Door Lock Switch With Motor Running; Motor Tach Signal Exists Without Motor Running; Te Abnormal High/Low Temp Or Ohm Resistance Seen - Maytag 27" Troubleshooting Manual

Diag. Description
Code
15 Stuck Key
Door switch
was not
seen open
17
since the last
three final
spins
Detected
door lock
switch open
18
during cycle
when not
expected.
19-21
Door switch
detected
22 open during
cycle (when
not paused).
23-24
Motor tach
signal exists
25 without
motor
running.
26-28
Sump
thermistor
29
failure
(Optional)
30-33
Trigger
A key is sensed to be pressed more than
30 seconds, the key will be assumed to be
stuck
The door has not been opened after two
complete wash cycles. Door switch was not
seen open since the last two final spins

Open door lock switch with motor running.

Door switch is detected open and the door
locked switch is read as locked.
Tach signal exists without torque command
or when not expected (Abnormal condition
only).
Abnormal high/low temp or ohm resistance
seen
Display "E2". Go to "Membrane
Pad Check" Check connection of
keypad to control board. Replace
Will display "od" If door open
Check for loose wire connections
Clear the diagnostic code and
recheck; if reoccurs, perform
Diagnostic Motor/Machine Control
Board test
faulty motor relay on the machine
control board.
Not Used
Not Used
Displays " bE". Replace Machine
Not Used
Displays " tE".
- Loose or pinched wires
- Bad sump thermistor
Not Used
18
Action to be taken
LED Board if necessary.
sensing, will cleared.
Check for
Go to "Door Lock Test"
Troubleshooting Section
Control Board.