On(G)/Standby(R) Indicator - Panasonic PT-CW230E Operating Instructions Manual

ON(G)/STANDBY(R) indicator

The <ON(G)/STANDBY(R)> indicator informs you the status of the power. Confirm the status of the <ON(G)/
STANDBY(R)> indicator before operating the projector.
ON(G)/STANDBY(R) indicator
Indicator status
No illumination or flashing
Lit
RED
Flashing
Lit
GREEN
Flashing
The power cord is unplugged.
The power cord is plugged.
The projector is in stand-by mode, after the cooling is completed.
The projector is cooling down. The projector cannot be turned on until cooling is
completed and the <ON(G)/STANDBY(R)> indicator stops blinking.
The temperature inside the projector is abnormally high and the projector is cooling
down. And the <WARNING> indicator also blinks in red (
cannot be turned on until cooling is completed and the <ON(G)/STANDBY(R)>
indicator stops blinking.
Projecting.
The projector is in stand-by status with [Power management] function.
The projection lamp will be turned on if the input signal is reconnected or any
button on the control panel or remote control is pressed. (
Powering ON/OFF
Status
Æ page 59). The projector
Æ
page 54)
25
ENGLISH -