Turning Off The Projector - Panasonic PT-CW230E Operating Instructions Manual

Powering ON/OFF

Turning Off the Projector

1 ) Press the <
the remote control, and Power off? appears on
the screen.
2 ) Press the <
the remote control again to turn off the projector.
The <ON(G)/STANDBY(R)> indicator starts to
blink red, and the cooling fans keep running.
At this time, you can unplug the AC power cord
even if the fans are still running.
3 ) When the projector has cooled down enough, the
<ON(G)/STANDBY(R)> indicator stops blinking
and you can turn on the projecto
Note
Do not put the projector in a case before the projector is
z
cooled enough.
<ON(G)/STANDBY(R)>
While the
z
the lamp is being cooled down and the projector cannot
be turned on. Wait until the
indicator stops blinking to turn on the projector again.
The projector can be turned on after the
z
STANDBY(R)>
indicator turns red. The waiting time
to restart will be shortened when the normal power-off
processing for fan cooling is completed, compared with
the time the AC power cord is immediately unplugged
after the power-off.
To protect the component parts inside the projector, the
z
fans normally start running again in approximately 40
seconds after turning off the projector. This is NORMAL
operation and not a malfunction.
Direct Power Off function
J
You can disconnect the power cord from the wall
outlet or turn off the breaker even during projection
without pressing the <
Note
When using the Direct power Off function, you can
z
not restart the projector immediately after the power is
disconnected. The lamp remains high temperature and
needs to be cooled, so it sometimes takes longer time
than usual for the lamp to light up again.
28
- ENGLISH
> button on the control panel or
> button on the control panel or
r.
indicator is blinking,
<ON(G)/STANDBY(R)>
<ON(G)/
> button.
Power off? disappears after 4 seconds.