On(G)/Standby(R) Indicator - Panasonic PT-VW340za Operating Instructions Manual

ON(G)/STANDBY(R) indicator

The ON(G)/STANDBY(R) indicator informs you the status of the power. Confirm the status of the <ON(G)/STANDBY(R)>
indicator before operating the projector.
ON(G)/STANDBY(R) indicator
Indicator status
Off
Lit
Red
Blinking
Orange Lit
Lit
Green
Blinking
*1: The indicator will light as the following order:
2.75 seconds (light) → 0.25 seconds (off) → 0.75 seconds (light) → 0.25 seconds (off)
*2: The indicator will light as the following order:
2.75 seconds (light) → 0.25 seconds (off)
*3: The indicator will light as the following order:
2.0 seconds (light) → 2.0 seconds (off)
*4: The indicator will light as the following order:
0.5 seconds (light) → 0.5 seconds (off)
Chapter 3 Basic Operations - Powering on/off
The power cord is unplugged.
The power cord is plugged.
The [STANDBY MODE] is set to [ECO] when the projector is in standby mode and the
cooling is completed.
The power is switched off (in standby mode). The [STANDBY MODE] is set to [NETWORK].
The power is switched off (in standby mode). The [STANDBY MODE] is set to [NORMAL].
The projector is cooling down. The power is switched off after a while. (Changes to the
standby mode.)
Projecting.
The power is on and the lamp is not working. The [POWER MANAGEMENT] is set to [READY].
*
The lamp starts work. The projector will project image after a while.
4
Status
*
1
*
2
*
3
ENGLISH - 35