Miele HG05 Operating Instructions Manual page 13


Do not connect the appliance to the mains electricity supply by a
multi-socket adapter or an extension lead. These do not guarantee
the required safety of the appliance (fire hazard).

The appliance must not be used in a non-stationary location (e.g.
on a ship).

Do not install the dishwasher in a room where there is a risk of
frost. Frozen hoses may burst or split. The reliability of the electronic
control unit may be impaired at temperatures below freezing point.

The plastic housing of the water connection contains an electrical
component. It must not be dipped in water.

There are electrical wires in the water inlet hose. Do not cut the
water inlet hose, even if it is too long.

The integrated Waterproof system offers protection from water
damage, provided the following conditions are met:
– The dishwasher is correctly installed and plumbed in.
– The dishwasher is properly maintained and parts are replaced
where it can be seen that this is necessary.
– The stopcock has been turned off when the appliance is not used
for a longer period of time (e.g. during holidays).
The Waterproof system will work even if the appliance is switched
off. However, the appliance must remain connected to the electricity
supply.

The water pressure (flow pressure at the take-off point) must be
between 30 and 1000 kPa (0.3 and 10 bar).

If the dishwasher gets damaged, switch it off at the mains
immediately and call your Miele Dealer or the Miele Service
Department.

While the appliance is under guarantee, repairs should only be
undertaken by a Miele authorised service technician. Otherwise the
guarantee is invalidated.
Warning and Safety instructions
13