›
Insert the plug
into the socket
A
›
Retighten the screws and insert the cap. The cap must engage firmly.
Changing the bulb for the licence plate light
ä
First read and observe the introductory information and safety warn-
ings
on page 169.
›
Open the luggage compartment door and unscrew the glass cover
›
Remove the faulty bulb from the holder and insert a new one.
›
Replace the glass cover and push in until the stop. Make sure that you install
the rubber seal in the right direction.
›
Slightly screw the glass cover.
Tail lamp assembly
Fig. 151 Removing the tail light assembly/disconnecting the plug connection
.
B
Fig. 150
Remove the licence plate light
» Fig.
Ð
Fig. 152 Remove the middle part of the light/bulb arrangement
ä
First read and observe the introductory information and safety warn-
ings
on page 169.
Bulb arrangement in the tail light assembly
- Brake lights
1
- Turn signal lights
2
150.
- Reversing light
3
- Rear fog light
4
- parking lights
5
Ð
Removing and installing the tail light
›
Open the boot lid.
›
Unscrew the light
» Fig. 151
›
Grip the light in the upper and lower area and move backwards somewhat.
›
Disconnect plug connection
›
To access the bulbs, unscrew the middle of the light and press off the latching
mechanism
» Fig. 152
›
To reinstall, screw the middle part of the light onto the housing of the rail light.
›
Reconnect the plug connection and put the light into the original position.
›
Screw the light into place
Replacing the bulbs in the tail lamp assembly
›
Remove the faulty bulb
new bulb.
›
To replace the bulb, turn the bulb holder
remove it from the housing.
›
Replace the bulb, insert the holder with the bulb into the housing and turn in a
clockwise direction to the the stop.
» Fig. 152
- .
» Fig. 151
- .
- .
,
,
or
» Fig. 152
from the holder and insert a
1
2
3
4
anti-clockwise up to the stop and
5
Fuses and light bulbs
Ð
173