Final Assembly; Attaching The Handle; Top Firebrick And Baffl E Installation - Napoleon NZ-26 Installation And Operating Instructions Manual

14

ATTACHING THE HANDLE

Attach the handle as shown so that
when the door is closed, the handle
will be centred in the slot located on the
fi replace front. To achieve this you may
have to experiment (on the upper and
lower screws) with one of the variations
shown. Tighten securely.
FIGURE 23
TOP FIREBRICK AND BAFFLE
INSTALLATION
The fi replace is shipped with the fi rebricks in place. Top fi rebricks,
fi bre baffl es and gasket rope are not installed.
TOP FIREBRICK TOP FIREBRICK
1
Unscrew and remove the front tube retainer. Note that the fi rst
1
tube retainer also holds the side brick in place. Slide the tube
either to the left or right and remove. Remove the two middle
tubes in the same fashion.
1
REAR REAR
BRICKS BRICKS
GASKET ROPE LOCATION GASKET ROPE LOCATION
2
2
Place gasket rope along the upper ledge of the air chamber
and on the top of the rear bricks. The top and bottom fl ame
spreaders come taped together. This tape will burn away in the initial
fi ring of the unit. On subsequent brick removals, the bottom fl ame
spreader must be taped to the top spreader to ease top brick and
baffl e removal and to avoid damaging the fi bre baffl es.
W415-0676 / 03.14.08
NorthlineExpress.com

FINAL ASSEMBLY

FIGURE 24
FIGURE 25
FIBRE BAFFLE FIBRE BAFFLE
TUBE TUBE
TUBE TUBE
RETAINER RETAINER
FIGURE 26 FIGURE 26
FIGURE 27 FIGURE 27
http://www.northlineexpress.com
TOP FLAME SPREADER TOP FLAME SPREADER
BOTTOM FLAME SPREADER BOTTOM FLAME SPREADER
FIBRE BAFFLE (1 OF 2 SHOWN) FIBRE BAFFLE (1 OF 2 SHOWN)
TOP FIREBRICK (1 OF 2 SHOWN) TOP FIREBRICK (1 OF 2 SHOWN)
3a
WARNING
!
Operation of the fi replace without the top fi rebricks and the
baffl es can result in excessive temperatures that could dam-
age the fi replace, chimney and the surrounding enclosure.
BAFFLE SUPPORT BRACKET BAFFLE SUPPORT BRACKET
3b
3 Insert the left baffl e, then the left top fi rebrick. Repeat using
the right baffl e and brick.
The baffl es are made of a brittle material. Care must be taken
not to bend or force them.
Replace the three front tubes. Position the center edg-
es of both baffles and bricks until they lie snugly together.
Slide the baffl e support bracket into place along the front of the unit
between the front tube and the two top fi rebricks.
4
FIGURE 28 FIGURE 28
FIGURE 29
FIGURE 30 FIGURE 30
Toll-Free 1-866-667-8454