Changing The Engine Oil - Toro GrandStand 74568TE Operator's Manual

Note: There are different oil capacities for the different
models listed in this manual. Ensure the correct amount
of oil is used.
Important: Remember to add 80% of the oil and
then gradually fill it to the full mark on the dipstick.
Oil Type: Detergent oil (API service SF, SG, SH, SJ
or SL)
Crankcase Capacity: 58 ounces (1.7 liter) with the filter
removed; 51 ounces (1.5 liter) without the filter removed
Viscosity: Refer to the table below
Checking the Engine Oil Level
Note: Check the oil when the engine is cold.
WARNING
Contact with hot surfaces may cause personal
injury.
Keep hands, feet, face, clothing and other body
parts away the muffler and other hot surfaces.
Important: Do not overfill the crankcase with oil
because damage to the engine may result. Do not
run engine with oil below the low mark because the
engine may be damaged.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure 42).
Figure 41
g015238
1
3
6
8

Changing the Engine Oil

Note: Dispose of the used oil at a recycling center.
1. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil drains
completely.
2. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
34
2
5
4
7
10
9
Figure 42
G008792