Operating The Ignition Switch; Using The Fuel Shut-Off Valve; Starting And Stopping The Engine - Toro GrandStand 74568TE Operator's Manual

1
2
Figure 12
1. On

Operating the Ignition Switch

1. Turn the ignition key to the Start position
(Figure 13). When the engines starts, release the key.
Important: Do not engage starter for more
than 5 seconds at a time. If the engine fails
to start allow a 15 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the
fuel system has been without fuel completely.
Figure 13
2. Turn the ignition key to stop to stop the engine.
G008959
2. Off
G008947

Using the Fuel Shut-Off Valve

Close the fuel shut-off valve for transport, maintenance,
and storage (Figure 14).
Ensure the fuel shut-off valve is open when starting
the engine.
1
2
G008948
1. On
Starting and Stopping the
Engine
Starting the Engine
1. Connect the wires to the spark plugs.
2. Open the fuel valve.
3. Move the right motion control lever to neutral
locked position.
4. Set the parking brake; refer to Setting the Parking
Brake.
5. Move the blade control switch (PTO) to the Off
position.
6. Move the throttle lever midway between the Slow
and Fast positions.
Note: A warm or hot engine may not require
choking.
18
g015365
Figure 14
2. Off