Checking The Engine Oil Level; Breaking In A New Machine; Think Safety First; Operating The Parking Brake - Toro GrandStand 74568TE Operator's Manual

Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline. To
minimize the chance of varnish deposits in the fuel
system, use fuel stabilizer at all times.
Filling the Fuel Tank
Note: Do not fill the fuel tank completely full. Fill the
fuel tank to the bottom of the filler neck. The empty
space in the tank allows the gasoline to expand.
1. Park the machine on level ground.
2. Shut the engine off and set the parking brake.
3. Clean around the fuel tank cap.
4. Fill the fuel tank to the bottom of the filler neck.
Ensure there is empty space in the tank to allow the
gasoline to expand Figure 7.
1
2
4
g015231
3
5
G012565
Figure 7

Checking the Engine Oil Level

Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to Checking
Oil Level in Engine Maintenance.

Breaking In a New Machine

New engines take time to develop full power. Mower
decks and drive systems have higher friction when new,
placing additional load on the engine. Allow 40 to 50
hours of break-in time for new machines to develop full
power and best performance.

Think Safety First

Carefully read all the safety instructions and decals in
the safety section. Knowing this information could
help you or any bystanders avoid injury.
The use of protective equipment for eyes, hearing, feet
and head is recommended.
CAUTION
This machine produces sound levels in excess of
85 dBA at the operator's ear and can cause hearing
loss through extended periods of exposure.
Wear hearing protection when operating this
machine.

Operating the Parking Brake

Always set the parking brake when you stop the
machine or leave it unattended. Before each use, check
the parking brake for proper operation.
If the parking brake does not hold securely, adjust it.
Refer to Servicing the Parking Brake.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it
is unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Setting the Parking Brake
Pull the parking brake lever rearward and over into
engaged position (Figure 8).
16