Mower Deck Maintenance; Servicing The Cutting Blades - Toro GrandStand 74568TE Operator's Manual

Checking the Hydraulic Lines
Service Interval: Every 100 hours
Check hydraulic hoses and hoses for leaks, loose fittings,
kinked hoses, loose mounting supports, wear, weather
and chemical deterioration. Make necessary repairs
before operating.
Note: Keep areas around hydraulic system clean from
grass and debris build up.
Note: Extended operating time at high temperatures
in a hot climate may lead to deterioration of hoses and
seals. Inspect more frequently in a hot climate and
change hydraulic oil and filter more frequently.
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• If hydraulic fluid is injected into the skin it
must be surgically removed within a few hours
by a doctor familiar with this type of injury.
Gangrene may result if this is not done.
• Keep body and hands away from pin hole leaks
or nozzles that eject high pressure hydraulic
fluid.
• Use cardboard or paper to find hydraulic leaks.
• Safely relieve all pressure in the hydraulic system
before performing any work on the hydraulic
system.
• Make sure all hydraulic fluid hoses and hoses are
in good condition and all hydraulic connections
and fittings are tight before applying pressure to
hydraulic system.
Mower Deck
Maintenance

Servicing the Cutting Blades

To ensure a superior quality of cut, keep the blades
sharp. For convenient sharpening and replacement, you
may want to keep extra blades on hand.
WARNING
A worn or damaged blade can break, and a piece
of the blade could be thrown into the operator's
or bystander's area, resulting in serious personal
injury or death.
• Inspect the blades periodically for wear or
damage.
• Replace a worn or damaged blade.
Before Inspecting or Servicing the
Blades
Park the machine on a level surface, disengage the blades
and set the parking brake. Turn the ignition key to off.
Remove the key and disconnect the spark plug wires
from the spark plugs.
Inspecting the Blades
Service Interval: Before each use or daily
1. Inspect the cutting edges (Figure 76). If the edges
are not sharp or have nicks, remove and sharpen the
blades. Refer to Sharpening the Blades.
2. Inspect the blades, especially the curved area. If you
notice any cracks, wear, or a slot forming in this area
immediately install a new blades (Figure 76).
1. Cutting Edge
2. Curved Area
53
Figure 76
3. Wear/slot Forming
4. Crack