Event Logging And Self Test - KVH Industries LTD9116MKIT User Manual

Self test
The Self test performs system test on the TracPhone system, similar to the tests
that are performed during the Power On Self Test (POST).
Important
To activate a Self test, do as follows:
1. Select HELPDESK > Self test.
2. Click Self test.
3. Click OK in the Warning dialogue.
The terminal now reboots and performs a self test.
Extended status
To see the Extended status page, select HELPDESK > Extended status.
To view updated information on the Extended status page, click Refresh.
The Extended Status page shows the following information:
• The antenna Product ID.
• The status of the connection to the air interface (IAI-2). This field should
normally show "Registered", unless the system is still in the startup
process.
• Ongoing data sessions (IP address) and connection status, e.g. Active or
Suspended.
• Ongoing calls and their connection status.
The terminal will reboot when performing the self test. All
ongoing calls or data sessions will be terminated.

Event logging and self test

Chapter 4: Using the web interface
197