Introduction; Figure 1 - Typical Wifi/Router Connection - Linksys E2500 Configuration Manual

Linksys® E2500 Wireless-N Router Configuration Guide
1

Introduction

®
Thank you for purchasing the Maretron preconfigured Linksys E2500 Wireless-N Router (from
here on referred to as WiFi/Router). The WiFi/Router is used to interconnect one or more wired
®
or wireless devices running Maretron's N2KView vessel monitoring and control software with
® ®
a device running Maretron's N2KServer (i.e., N2KServer runs on Maretron's Internet
®
Protocol Gateway (IPG100) or a PC connected to an NMEA 2000 network via Maretron's
USB gateway (USB100)). Figure 1 shows a typical configuration where multiple devices
®
running Maretron's N2KView software (e.g., laptop computer, desktop computer, smart
phone, tablet, Maretron DSM800 display, or Maretron MBB100 black box) are connected back
®
to an NMEA 2000 network through the WiFi/Router and the Maretron Internet Protocol
Gateway (IPG100).

Figure 1 - Typical WiFi/Router Connection

Although the WiFi/Router is mostly pre-configured by Maretron, there are a few steps that must
®
be performed to establish the connection between Maretron's N2KView vessel monitoring
Page 4 Revision 1.0